美國 Monarch Instrument ACT-1B 面板轉速表
ACT-3X 面板轉速表是一款功能強大的 NIST 校準、完全可編程的轉速表和累加器。它接受來自 Monarch 速度傳感器或任何標準 TTL 生成設備的輸入。該裝置由 120/240 V 交流輸入電源或 12 或 24 V 直流輸入電源（可選）供電?？赏ㄟ^ 5 個前面板按鈕或使用免費下載的 PM 遠程軟件輕松進行編程。設置為單通道監控?？删幊瘫壤蜃?，菜單選擇每轉多個脈沖、線性速率、單事件跳閘速度（使用輔助輸入）和 RPM 變化率。TTL 脈沖中繼器輸出為標準配置。建議使用的傳感器有 PN -W（= 鍍錫引線）、ROS-W、ROS-HT-W-25、 P5-11、PS-12、 M-190W、 IRS-W、 ROLS-W 、 RLS-W、 SLS-115/230、CSLS和 GE-200HP燃氣發動機傳感器（帶放大器）。
特征
型號 – 通用輸入，通過光學、紅外、激光、接近和磁傳感器或直接 TTL 和 200 mV 至 50 V 交流信號進行非接觸式操作
ACT-3X 面板轉速表
1/8 DIN 尺寸
5位LED顯示屏
轉速范圍：5 至 999,990 RPM
通用傳感器輸入
包含 NIST 可追溯證書
用戶可使用前面板按鈕或免費下載 PM 遠程軟件進行配置
在電腦上查看實時數據*
以 .CSV 格式實時記錄數據*
通用交流電源 100-240 V 交流電，50/60 Hz 或可選 12 或 24 V 直流電源
標準脈沖中繼輸出
從啟停脈沖中捕獲單個事件，單位包括 MPH、CM/秒等使用 二傳感器 – 用于測量第二輸入通道的線性行進速率
可選 4-20 mA 或 0-5 V dc 可擴展輸出
可選以太網或 USB 通信
可選報警繼電器輸出
參數*
| Speed Range | 5-999,999 RPM (speeds below 5 RPM possible with multiple pulses per revolution) |
| Input Frequency Range | 0.083 Hz to 80 kHz |
| Totalizer/Counter | Display Range: 0.001 to 99,999 |
| Input Configuration | Universal inputs: 1 to 9,999 pulses per revolution front panel pushbutton programmable TTL input and 1.1 V to 50 V ac signals, Opt: -1 to -50 V dc |
| Accuracy | +/-0.001% of reading or +/-1 displayed resolution (standard gate), +/-0.06% of reading or +/-1 displayed resolution (fast gate) |
| Resolution | Up to 0.001 RPM, 10 RPM (100,000 to 999,990 RPM) |
| Display | 5-digit, 0.56 in. [14 mm] high red LED |
| Display and Output Update | Menu-selectable between 0.5 seconds above 120 RPM, 1 second above 60 RPM, and 1.5 seconds above 40 RPM |
| Max Measurement Rate | Up to 100 times per second (Standard Gate) or up to 1000 (Fast Gate) dependent on the input frequency; input must be measurement rate |
| Scaling | Programmable scaling: 0.0001 to 9999.9 (front panel pushbutton programmable) |
| Decimal Point | User-selectable (0-3) decimal places max (front panel pushbutton programmable) |
| Memory | Maximum, minimum, and last reading recall from front panel pushbuttons |
| Dimensions | 1/8 DIN by 4.5 in. [114 mm] deep Panel cutout: 3.58 in. x 1.74 in. [91 x 44 mm] |
| Input Power | Standard: 100-240 V ac +/-10%, 50/60 Hz Optional: 12 or 24 V dc +/-20%, isolated, 8VA |
| Inputs | Universal input for optical, proximity, two-wire or three-wire magnetic, infrared, or laser sensors; TTL input or 3.3 V ac to 50 V ac input (The standard input is 1 pulse per revolution.) |
| Sensor Excitation | 5 V dc or optional 12 or 24 V dc to sensor |
| Recommended Sensors | LED – ROS-W High Temp – ROS-HT-W-25 Proximity – P5-11, PS-12 Magnetic – M-190W or MT-190W Infrared – IRS-W Laser – ROLS-W, RLS-W, SLS-115/230, CSLS Inductive – GE200-HP Gas Engine (requires amplifier) |
| Pulse Repeater Output | Standard, 0 to 5 V TTL compatible; one pulse out for each pulse in Menu-selectable polarity |
| Communications | Bidirectional RS232C, USB, or Ethernet interface |
| Analog Output (optional) | Voltage (AO): 0 to 5 V dc, 5 mA max load (isolated or non-isolated) or Current (IO): 4 to 20 mA, 500 ohm,| max load. (or non-isolated), 1 to 5 V dc possible using 250 ohm resistor) 16-bit resolution Front panel pushbutton programmable for full scale and offset RPM ranges |
| Pulse Output (optional) | Repeater pulse output: TTL pulse switching between +5 V and ground |
| Alarm Capability | Two-alarm setpoints: High or Low alarm limits, latching or non-latching Front panel pushbutton programmable Hysteresis, deadband, and low limit lockout are programmable; relays can be set as a fail-safe Alarms can be reset manually or automatically; remote reset via the auxiliary input |
| Alarm Outputs | Two Form C relay contacts, rated 1 A at 115 V ac or 230 V ac |
| Remote Programming | Remote programming is possible using an optional communications interface and PM Remote Software (If no communications are ordered, the unit can still be programmed with an optional USB programming cable.) |
| Environmental | Indoor use only, installation category II per IEC 664 temperature: -10 °C to 50 °C operating per IEC 61010-1 Humidity: maximum relative humidity 80% for temperatures up to 31 °C, decreasing linearly to 50% relative humidity at 40 °C |
| Electrical Safety | Meets EN61010-1:2001, EC low voltage directive 72/23/EEC and 89/336/EEC |
添加微信咨詢！